Simucube 2 Pro blocked on "Read-Only Profile"

Giotto Bizzarrini · Friday at 22:47

Hello everyone.

I installed the TruDrive and I cannot escape the "read-only profile".
It also says "e-stop pressed" even if I unplug it.

Every part of the interface is disabled.

Is there anything I can do?
Thanks.

Michael Krone · Saturday at 13:22

I get this quite often and for me its because of the power supply. Not sure why but the green light is always off when it happens. Is the light on -on your power supply?

Giotto Bizzarrini · Saturday at 14:05

Thanks, Michael. I’ll check and report my observation here.

The one in the back of the SC instead is green as I boot and then blue.

Michael Krone · Saturday at 14:14

Im talking about the actual power supply, the power brick itself should have a small green light in the corner. Mine goes out and causes the issue you describe.